Supply Voltage and Current
·+12 VDC, nominal（+9 VDC to +15 VDC）
·85 mA, typical at +12 VDC. Average power dissipation is 1 W, typical.
·Supply must be capable of sourcing 200 mA, minimum.
·Total noise and ripple requirement must be less than 100 mV (p-p) for frequency below 1 MHz, and less than 50 mV (p-p) for frequency above 1 MHz.
Interface
·EIA 232E (Serial RS-232), DCE configuration. 8 Data Bits, 1 Stop Bit, No Parity, full Duplex.
Baud Rate
·9600 Operating Modes
Touch Resolution
·4096x4096, size independent, 256 levels of Z axis (pressure)
Conversion Time
·Approximately 16 ms per coordinate set (including transmitting time)
|
|
Reliability
· MTBF greater than 200,000 hours per MIL-HDBK-217-F2 using the parts stress calculation method for ground benign environment with an ambient temperature of 40°C.
Environmental Temperature
·Operating: 0°C to 65°C
·Storage: -25°C to 85°C
Humidity
·Operating: 10% to 90% RH, non-condensing
·Storage: 10% to 90% RH, non-condensing
ESD
·Per EN 6100-4-2 : Contact discharge 4kV, air discharge 8kV.
Flammability
·The printed circuit board substrate is rated 94V0. All plastic components, such as headers and connectors, are also rated 94V0.
|
